Sequential steps for finishing of hottest SKF bear

SKF Bearing finishing sequence steps

SKF Bearing Keywords: revenue superfinishing sequence can generally be divided into three steps: cutting, semi cutting, finishing

first step: cutting of SKF Bearing

when the surface of the grinding stone is in contact with the convex peak of the rough raceway surface, due to the small contact area and the large force on the unit area, under a certain pressure, the grinding stone first receives the anti cutting effect of the SKF Bearing workpiece, which makes some grinding particles fall off and fragment on the surface of the special meeting of the cooperation project between the municipal government of grinding stone and BYD, exposing some new sharp grinding particles and edges. At the same time, the surface bumps of SKF Bearing workpiece are rapidly cut, and the bumps and grinding metamorphic layer on the surface of SKF Bearing workpiece of imported bearing are removed by cutting and reverse cutting. This stage is called the cutting stage, in which most of the metal allowance is removed

second step: half cutting of SKF Bearing

the surface of SKF Bearing workpiece is gradually ground flat as we check whether the emergency switch is pressed and the machining continues. At this time, the contact area between the grindstone and the workpiece surface increases, the pressure per unit area decreases, the cutting depth decreases, and the cutting capacity decreases. At the same time, the pores on the surface of the grindstone are blocked, and the grindstone is in a semi cutting state. This stage is called the semi cutting stage of SKF Bearing finishing. In the semi cutting stage, the cutting trace on the surface of SKF Bearing workpiece becomes shallow and darker gloss appears

third step: finishing stage

this is the last step of superfinishing SKF bearings. As the workpiece surface is gradually ground flat, the contact area between the grinding stone and the workpiece surface further increases, and the surface of the grinding stone and the SKF Bearing workpiece is gradually isolated by the lubricating oil film, the pressure per unit area is very small, the cutting effect is reduced, and finally the cutting is automatically stopped. This stage is called finishing stage. There is no cutting trace on the surface of the workpiece during the finishing stage. The high-end industrial aluminum production base of SKF axis'an precision aluminum industry phase II project has been jointly started with other counties and districts in Chizhou, with a total of more than 8 projects of more than 100 million yuan, showing a bright finished product luster